We want to know how to balance before critical work, but we don't have any calibration or theory knowledge. What should we do?

If you want to perform balancing before a critical job but lack calibration and theory knowledge, there's no need to worry. In this case, the safest and most practical method is to work with an accuracy of half the balancing tolerance. For example, if your part's acceptable tolerance is 50 gmm, you can set the machine with a remaining imbalance target of 25 gmm. This approach minimizes potential risks by reducing the part's imbalance level to a reasonable range. This presetting ensures you've reached the correct reference point and balances the part well below the accepted tolerance.

Following this process, you should carefully check the remaining imbalance amount and angle before performing any corrections. If the remaining imbalance is at or below this predetermined half-tolerance, the process is considered successful. At MBS Balance, our machines, with their user-friendly interfaces and automatic calculation capabilities, make it easy to take the right steps even in such situations. Our machine's sensitive sensors and software clearly display the remaining imbalance and angle, so you know what to do at each step. This practical method compensates for a lack of theoretical knowledge, enabling you to achieve successful and safe results in your critical tasks. However, it's important to remember that for the most efficient and accurate long-term results, the best approach is to fully calibrate the machine and learn proper balancing principles.

The key to working safely without theoretical knowledge is to use the machine's guided mode and to enter all part data completely. When the target G grade, rotor mass, correction radii, and plane positions are entered, the software itself calculates the permissible residual unbalance per ISO 21940-11 and gives you only the instruction to add this much weight at this angle. The polar display lets you follow the direction of the unbalance intuitively.

Making a proving run during the first setup confirms that the system gives correct results: a known trial weight is added and it is checked whether the machine reads it at the correct amount and angle. Starting with a half-tolerance target also leaves a safety margin. With its user-friendly interface and hands-on training support, MBS Balance enables the operator to obtain safe results in a short time; after the critical job is finished, we recommend that you receive full calibration and basic balancing training.